v2.8.6 - Latest

1 Mar 2026

• Added fallback option so that offline chargers continue to work as a "dumb charger" beyond the 28-day schedule limit (this is the default).
• Improved thermal performance at high ambient temperatures for Rev H and beyond E2 PCBs.
• Fixed control pilot signal timing to suit Ford vehicles

---

v2.8.3

16 Feb 2026

• Improved thermal performance at high ambient temperatures for pre-Rev H E2 PCBs.
• Widened control pilot voltage tolerance to suit Deepal models
• Changed current limit threshold to suit BYD models drawing more current than offered.

---

v2.8.0

30 Oct 2025

• Added support for E2 Rev H PCB, including external power sensor
• Meter values can now be sent in a data transfer message to reduce message size
• Changes to solar control to support BYD Sharks and Sealions.

---

v2.6.6

19 Jun 2025

• Added offered current as a MeterValues measurand
• Changed overcurrent fault detection to avoid nuisance detection at low charging currents during transient conditions.
• Added timeout to Charge Now state
• Fixed RCM self-test timing

---

v2.6.2

31 Jan 2025

• Added support for E2 Core
• Changes to overcurrent limiting threshold to support BYD vehicles during Solar diversion / Home overload protection.
• Increased size of charging schedule profiles for weekly repeating schedules
• Added support for Kore SIMs on Telit modems
• Improved solar control for MG4 vehicles

---

v2.5.4

17 Sep 2024

• Added support for Import Current Limit
• Enabled adjustable import / export target during solar diversion to avoid draining batteries
• Local Load Management now supports solar diversion
• Energy meter values can now be read over Bluetooth by the installer app

---

v2.4.4

1 May 2024

• Added ShortButtonPress and LongButtonPress mode settings
• Changed SIM card ready timing to suit Kore SIM cards
• Added control pilot duty to GetAnalog data transfer message
• Extended contact detection times

---

v2.4.1

11 Jan 2024

• Changed RCM self test timing to support new model RCM
• Added generation of separate supply active import and export meter values
• Added Anti-Sleep functionality

---

v2.3.0

31 Oct 2023

• Changes to solar control to prevent home battery discharge.
• Heartbeat messages were not always sent causing long term internal clock drift

---

v2.2.1

21st Sep 2023

• LLM - When over capacity, longest charging chargers may not be dropped on L2 and L3.
• LLM - Did not correctly allocate charging current for some combinations of three phase charging and charge now
• Failed firmware downloads were not erased from flash (Could load E2 firmware on EX and vice versa)
• Networking was turned off before websocket close message could be sent by modem
• Changed GetLLM data transfer message to always return values for all three phases
• Reduced LLM ping interval to help reduce lost ping messages on WiF
• Improvements to Telit modem driver, particularly for V6 modem firmware on Twilio SIM

---

v2.1.0

26th Jun 2023

• Telit cell modem OTA update - Added CellCommand data transfer message to initiate the OTA firmware update procedure
• Temporary Availability - Added TempAvail data transfer message to allow overriding of the connector availability settings for a time period so a charge point can be tested during installation.
• LLM single phase clients would show as charging on phase ALL on each charge cycle after the first charge
• Allow disabling LLM discovery on WiFi

---

v2.0.0

6th Apr 2023

• Initial release

---